Sunburn Burnishable System
SunBurn Burnishable Stain System provides a color solution utilizing nano-lithium based technology that colors and hardens the concrete.
SunBurn
Color that Hardens
Experience the ultimate in concrete performance. SunBurn utilizes advanced nano-lithium technology to infuse surfaces with vibrant, permanent pigment while simultaneously hardening the concrete at a molecular level. The result is a superior, wear-resistant finish that will never flake, peel, or wash out. Available in a wide range of striking shades, SunBurn is the premier choice for delivering lasting beauty to commercial and residential projects alike.
Burnishable Stain Colors
Burnishable Stain Solid Colors
The colors above represent two to three coats applied on typical gray concrete. Coloration is translucent and will highlight concrete color and texture variation. The Burnishable Solid Stain is much less translucent; however, will also vary with the concrete color and texture variation. Additional coats will provide more color and hide imperfections. The colors on this chart are representations only and attempt to approximate the final appearance of colored concrete. It is strongly advised that the selection of color is made from a sample prior to installation.
Features and benefits
Establish a permanent chemical bond that hardens the concrete while delivering durable color. With options for both translucent and opaque finishes, you can achieve the exact look your customer requires.
- Creates a durable color that is chemically bonded to the surface
- This application hardens and protects the concrete; easy to maintain
- Available in both translucent and opaque color options
- Low-VOC, environmentally friendly, and has very little odor
- Resembles the look of polished concrete floors
- Provides protection against UV radiation, water intrusion, corrosion, and chemicals
Where to use
Some of the most common installations include:
- Driveways
- Patios
- Garage Floors
- Porte-Cochere
- Outdoor Kitchen
- Living Spaces
- Walkways
- Entryways
- Courtyards
- Lobbies
- Basements
- Retail Floors
- Residential or Commercial
- Indoor & Outdoor
SunBurn interior
Follow these steps when using SunBurn indoors:
- The surface is prepared with a minimum of 2 passes using finer diamond pads on the burnisher.
- Using a pump-up sprayer, apply and scrub into concrete.
- After 60 minutes of dry time, perform another pass with the burnisher.
- Apply additional coats in the same manner to achieve the desired color level.
- Burnish between coats.
- Apply SunBurn Burnish Guard light penetrating sealer to enhance the sheen.
SunBurn exterior
Follow these steps when using SunBurn outdoors:
- Pressure wash area.
- Using a pump-up sprayer, apply and scrub into the concrete.
- After 60 minutes of dry time, apply another coat of color as desired.
- Apply SunBurn Burnish Guard light penetrating sealer to enhance the sheen.
*To avoid a slippery surface, we do not recommend you burnish exterior applications.
Sunburn Burnishable System Photo Gallery
Unrivaled Aesthetics. Uncompromising Durability.
